1.In the current RF environment, the noise floor is -95 dBm. A tablet needs an SNR of 25 dB to transmit at the required speed.
What must the RSSI cell edge be to meet the required SNR?
A. -120 dBm
B. -90 dBm
C. -70 dBm
D. -60 dBm
E. -50 dBm
Answer: C
2.An access point is currently transmitting at 4 mW. The customer needs to increase its signal strength by 6 dB to create a larger wireless cell.
What should the new transmit power be?
A. 8 mW
B. 10 mW
C. 12 mW
D. 16 mW
E. 24 mW
Answer: D
3.A wireless engineer is designing the wireless networking for a company with offices in two different locations.
Which two regulatory bodies should they check to find the maximum EIRP allowed? (Choose two.)
A. IEEE
B. FCC
C. ITU-R
D. ETSI
E. Wi-Fi Alliance
Answer: B, D
4.After installing a Cisco 5508 Wireless Controller using the default settings, how often will the RRM update occur?
A. 30 seconds
B. 60 seconds
C. 300 seconds
D. 600 seconds
E. 3600 seconds
F. 7200 seconds
Answer: D
5.A customer has requested a single point of policy enforcement for LAN and WLAN.
Which deployment model should be used?
A. converged
B. autonomous
C. FlexConnect
D. centralized
Answer: A
6.A customer has asked for the proper port configuration to allow for LAG on a Cisco 2504 Wireless Controller to a Cisco IOS switch.
Which EtherChannel mode should be used on the switch to allow for the WLC to connect?
A. on
B. auto
C. desirable
D. passive
E. active
Answer: A
7.A customer has asked for its wireless equipment to be managed as securely as possible.
Which three management protocols will provide encrypted access to the equipment? (Choose three.)
A. Secure Shell
B. HTTPS
C. SNMPv3
D. Telnet
E. SNMPv2c
F. HTTP
Answer: A, B, C
8.When deploying a Cisco Cloud Wireless Infrastructure, what two destination ports must be open? (Choose two.)
A. TCP/5246
B. UDP/5246
C. TCP/5247
D. UDP/5247
E. TCP/7351
F. UDP/7351
G. TCP/7734
H. UDP/7734
Answer: F, G
9.A help desk engineer is attempting to perform a remote packet capture on the wireless network.
Which access point mode is necessary to perform this function?
A. sniffer
B. SE-Connect
C. monitor
D. rogue detector
E. FlexConnect
Answer: A
10.An engineer has been asked to upgrade the FUS on the Wireless LAN controller.
How can they monitor the status of the upgrade?
A. WLC GUI
B. WLC CLI
C. WLC Console
D. WLC Management in Prime Infrastructure
Answer: C
11.During a wireless site survey, the signal strength drops significantly when outside of the room containing the access point. The building is made of wood and drywall.
This is an example of which wireless anomaly?
A. absorption
B. refraction
C. fading
D. multipath
E. reflection
Answer: A
12.A wireless engineer has been asked to plan a deployment covering the aisles of a warehouse with optimal coverage while bleeding RF across aisles.
Which antenna type provides the necessary coverage?
